The X5000E is Shacman's battery electric tractor built on the X5000 cab and chassis, in a 6x4 layout. It is not a concept vehicle. Fleets in China are running it on port shuttles, steel mill loops, coal yard hauls and short regional runs, and the drivers report on it daily. This article covers what matters to a buyer: how far it goes, how long it charges, what it costs per kilometre, and where it stops making sense.
The truck uses lithium iron phosphate cells in two pack sizes, roughly in the 350 kWh and 423 kWh band. LFP is the right chemistry for a working truck: it tolerates daily full charging, holds up in hot yards, and does not need the careful charge windows that earlier chemistries did. The drive motor is permanent magnet synchronous, coupled to a multi-speed AMT, so the truck pulls away on torque rather than on clutch slip. Regenerative braking feeds energy back on every downhill and every stop, which on a port loop is most of the day.
Published range figures are measured on a test cycle, and no fleet drives a test cycle. On a loaded 6x4 tractor the practical figure is shorter. As a working guide:
Ask any supplier for the charge curve, not just the range number. The curve tells you whether the last 20 percent takes twenty minutes or an hour, and that number decides whether a truck fits a two shift schedule.
| Item | Typical figure |
|---|---|
| Charger type | DC fast charge, dual gun |
| Charger power | 400 kW and above |
| 20 to 80 percent | About 45 to 60 minutes |
| Full charge overnight | AC depot charging, 6 to 8 hours |
Most fleets we quote run one charger for two to three trucks and charge during the driver's break plus overnight. If the depot cannot take a 400 kW load, tell us before the truck is specified, because the charger is usually the longer lead item, not the truck.
Electricity at depot rates is the headline saving, and on a port loop it is large. The second saving is quieter and often bigger: brake linings, clutch parts, engine oil, filters and exhaust treatment all disappear from the maintenance schedule. What replaces them is tyre wear and an annual battery health check. Fleets should model three years, not one, because the purchase price gap closes fastest on high-utilisation routes.
Buy the electric tractor when the truck returns to a base every day and the route is under 200 km loaded. Ports, steel yards, cement plants, warehouses on fixed shuttle runs and city construction supply all fit that pattern. Do not buy it for 800 km line haul with no charging on the way, and do not buy it if the depot has no power capacity. That is not a limitation of this model, it is physics and infrastructure.
The cab is the familiar X5000 layout: flat floor, air seat, tilt and telescopic steering, and the same switch positions drivers already know. Electric driveline noise is low, which drivers notice on the first shift, and it makes the reverse alarm and the yard radio easier to hear. Driver acceptance is usually the fastest part of the switch, not the slowest.
Route length, loaded and empty, plus the steepest gradient. Daily distance and how many shifts. Depot power available, and whether a charger is included. Body type, fifth wheel or rigid. Send those four things and we will quote the right pack size instead of the biggest one.
Contact our team for the current X5000E specification sheet, charging options and delivery schedule.