banner banner

Blog Details

Created with Pixso. Home Created with Pixso. Blog Created with Pixso.

Mining Dump Truck Preventive Maintenance Schedule by Engine Hours and Parts List

Mining Dump Truck Preventive Maintenance Schedule by Engine Hours and Parts List

2026-11-20

Preventive maintenance schedule for a mining dump truck, by engine hours

Mining tippers live or die on the service book. A truck serviced by feel, when the driver complains, will lose more days to repair in a year than a truck serviced by hours. This is the schedule we recommend to fleets running tippers on site, and the parts worth keeping on the shelf.

The schedule

IntervalWork
Every shiftTyre pressure and condition, oil and coolant level, brake air pressure build up, body and hoist visual check
250 hoursEngine oil and filter, fuel filter, air filter check, grease all pins, check hoist cylinder seals
500 hoursAir filter replace, gearbox and axle oil check, brake adjustment, suspension and spring eye inspection
1,000 hoursValve clearance check, cooling system flush check, thermostat test, belt and tensioner inspection, driveline bolts torque check
2,000 hoursInjector test, turbo boost check, clutch and release bearing inspection, brake chamber overhaul
5,000 hoursCylinder head inspection, head gasket and liner assessment, frame crack inspection at cross members

Why the 1,000 hour mark matters most

This is where small failures become engine failures. A sticking thermostat runs the engine cold on night shift, then hot at midday, and the head gasket takes the punishment. Testing the thermostat and the coolant circuit at 1,000 hours costs a fraction of a top end rebuild. A replacement thermostat assembly is a shelf item, not a special order.

The parts that stop a shift

  • Starter motor and alternator: one each per 10 trucks is cheap insurance
  • Belts, tensioners and a spare fan clutch
  • Brake chambers and air valves
  • Head gasket and injector washers for the 5,000 hour inspection
  • Clutch cover and release bearing for trucks past 3,000 hours

Stocking list examples from our own catalogue: cylinder head gasket BY612600040355, 430mm diaphragm spring clutch cover, plus the wear items matched to your engine model. A shelf of these costs less than three days of lost production.

Driver checks feed the schedule

The daily check sheet is the cheapest diagnostic tool on site. A driver who records coolant top up volumes will find a seeping hose two weeks before it bursts. A driver who records tyre pressures will find a slow puncture before the casing is ruined. Give the shift supervisor a simple sheet with five lines, and review it weekly, not monthly.

Records beat opinions

Keep hours, not kilometres, as the primary interval on site trucks. Idling and low speed hauling inflate engine hours relative to distance, and a truck that reads 40,000 km may have run 1,800 hours. Every major failure we have investigated on mining tippers traced back to intervals being measured in kilometres.

Match the schedule to the truck

A 340-450HP Euro 2 mining tipper on 20 hour operation will reach 5,000 hours inside a year, so the whole table runs in twelve months. Set the plan before the truck arrives, not after the first breakdown. Our dump truck range page lists the models this schedule applies to.